The SimplyVAV series of controllers are an easy and
unique approach to operating a wide variety of VAV
terminal units. The integrated actuators, internal
airflow sensors, and wide variety of application
programs make these BACnet Application
Specific controllers ideal for either new or retrofit
Easy to install Just mount the controller, wire it
to a 24 volt transformer, and then connect airflow
and temperature sensors. A SimplyVAV controller
automatically detects sensors as they are connected
without special programming or software tools.
Simple, menu driven setup The controllers feature
simple, menu driven setup choices. No special
programming skills or software tools are required
to choose applications, enter setpoints, set network
addressing, and balance airflow. All options can
be set by using only an STE-8001 sensor which
can be installed as the permanent room sensor or
temporarily connected as a technician’s service tool.
New or retrofit applications The SimplyVAV
controllers are ideal for new installations or
upgrades of older, less efficient controllers.
? Staged, modulated, floating, or time proportional
? Series or parallel fan control
? Single or dual duct application
Native BACnet All models are BACnet Application
Specific Controllers that are ready to connect to a
BACnet MS/TP network. Device instance, MAC
address, and baud rate are set from an STE-8001
without special software.
Easy system integration For SimplyVAV
installations that are part of a BACnet building
automation system, the controllers provide system
diagnostic indicators. Through the MS/TP network,
the controllers signal demands for higher static duct
pressure, cooler or warmer supply air, and when to
start air handler units.